27
Network Camera User Manual
Use IP address (take IPv4 for example)-
There are two options for IP setup: obtain an IP
address automatically by DHCP protocol and use the following IP address. Please choose one
of the options as needed.
Test: Test the effectiveness of the IP address by clicking this button.
Use PPPoE-
Click the “PPPoE Config” tab to go to the interface as shown below. Enable
PPPoE and then enter the user name and password from your ISP.
Either method of network connection can be used. If PPPoE is used to connect internet, the
camera will get a dynamic WAN IP address. This IP address will change frequently. To be
notified, the IP change notification function can be used.
Click “IP Change Notification Config” to go to the interface as shown below.
Trigger Email
: when the IP address of the device is changed, the new IP address will be sent to
the email address that has been set up.
Trigger FTP
: when the IP address of the device is changed, the new IP address will be sent to
FTP server that has been set up.
