TechPlus ComfortAire, Service Supplement Manual

Page: 41 / 86

l
TechPlus
s e r v i c e s u p p l e m e n t
both the pulley and the drive plate must be replaced. There should also be
no foreign matter, such as oil or grit, lodged between the drive plate and
pulley. Thoroughly clean these contact surfaces and the drive plate.
3.
Coil:
Inspect the coil for a loose connector or cracked insulation. If the
insulation is cracked, replace the coil. Repair or replace the wire or
connector if either is loose or damaged.
Clutch Removal
Note: Make sure the proper tools are available before performing
maintenance procedure.
1. Remove the center bolt using the puller arbor to prevent drive plate
rotation.
2. Remove the drive plate by using the shaft seal kit. Then remove the shims
from either the driveshaft or the drive plate.
3. Remove the snap rings using external snap ring pliers.
0
1
APPENDIX
c c
8 0