Technoton MasterCAN C 232, Operation Manual

Page: 47 / 62

MasterCAN configuration with the service kit / Service MasterCAN software operation / MasterCAN settings
MasterCAN Vehicle Data Interfaces. Operation manual. Version 4.0
© Technoton, 2017 47
3.6.3 MasterCAN settings
Settings area (see figure 25) provides the following options:
1) Output protocol type for MasterCAN C 232/485 or MasterCAN V-GATE according to
1.5.3 , 1.5.4 :
 text (ASCII) ;
 MODBUS ;
 DUTE-COM .
2) MODBUS (DUTE-COM) address to set network address for MasterCAN C 232/485 or
MasterCAN V-GATE when those are used as summators of DUT-E CAN fuel level sensors. By
default MasterCAN network address is equal to two last serial number digits;
3) FMS Messages Sending Permit to enable/disable output of FMS messages by
MasterCAN CC or MasterCAN V-GATE output interface
(see 1.5.2 , 1.5.4 );
4) Telematics Messages Sending Permit to enable/disable output of Telematics
messages by MasterCAN CC or MasterCAN V-GATE output interface
(see 1.5.2 , 1.5.4 );
5) CAN Request Permit to enable/disable of sending requests into CANbus by input
interface of MasterCAN CC, MasterCAN C 232/485 or MasterCAN V-GATE. Active Requests
are used for gathering of the following information from automotive CANbus:
 PGN 65216 – service information;
 PGN 65253 - engine operation time, RPMs;
 PGN 65257 - fuel (liquid) consumption.
ATTENTION :
1) Active requests sent into CANbus can cause malfunctions of vehicle equipment.
2) Active requests sending is only possible for direct bus connections of
MasterCAN to CANbus. Requests cannot be sent when connecting with
contactless
Crocodile reader.
6) J1708 Request Permit — requests not transmitted to automotive J1708bus for current
version of software.
7) ASCII Message Interval, ms used to set a time period for sending output messages
from MasterCAN C 232/485 or MasterCAN V-GATE according to ASCII standard (see 1.5.3 ,
1.5.4 and annex B ).
Interval can be set in range from 100 to 65535 ms (with 1 ms step). Default value
is 100 ms.