5
Updated
: June 16
Assembly Instruction for the KBS Pew Heat-Radiator
Electrical installation
Only authorised electricians may install and mount the bench heaters.
1) Fastening / cover
2)
Cable gromme
t
3) Clamp
4)
Fastenin
g
5) Steatite piece
6) Quartz heating element
7) Aluminium reflector/ mirror
Remove the cover grid and mount the heater under the sitting surface (in the middle of
the bench). Mount the supply line on the bottom of the bench and lead it in on the front
side of the heater. The heaters are wired-through at 1.5 mm.
Should several heaters be mounted on one bench, one heater can be plugged into the
one opposite and fed into the next one. Heaters up to a total load of 3000 Watts can be
connected in series. The TECHNOTHERM church bench heater boasts a chromium-
nickel steel heating element.
The advantage: non-brittle and non-corrosive! After the electrical instalment, remount
the cover grid from below with the lock washer and the screw. The heaters have to be
completely (all poles) disconnectable from the mains power supply by using switches,
contactors or automatic disconnecting devices at a minimum distance of 3 mm between
contacts. Make sure the phase load is even. Use an electronic thermostat with variable
continuous contact for controlling. Install a heating time limit (set to 6 h) and a timer to
automatically start the heater.
We will gladly provide circuit diagrams tailored for your project listing the electrical
controls used.
1
5
6
2
3
4
7
GB
