AS Series
Technomad AS Series loudspeakers can be set up quickly and efficiently in
many configurations. The AS Series includes the Noho C, , Berlin 15/H,
Cairo 15/C full- range loudspeakers and Soho 12 Chicago 15/12 sub-
woofers.
Stand Mounting
All Technomad AS Series loudspeakers feature
four
1.5” diameter stand
mounting sockets - one per side - molded directly into the cabinet.
Technomad’s stand mounting sockets are flush with the surface of the
loudspeaker cabinet to allow for quick and easy set-up, break-down, and
storage.
MonitorTilt™
Technomad AS Series loudspeakers include 1.5” diameter sockets on the
rear of the loudspeakers which allow any AS Series loudspeaker to be
used as a monitor. Two lengths of 1.5” tubing are inserted into these sock-
ets to angle the loudspeaker to the appropriate angle. The angle of the tilt
can be adjusted through the use of different length tubing.
Flying
WARNING: Suspending any object is a potentially dangerous and should
only be attempted by qualified individuals.
AS Series Technomad loudspeakers are equipped with flying points. The
Noho C and Soho 12 loudspeakers are equipped with 4x 1/4-20 threaded
inserts on the top and side. The Berlin 15/H, Cairo 15/C and Chicago
15/12 loudspeakers all feature 4x 3/8-16 threaded inserts on all sides. All
flypoints are rated at 10:1. All flypoints allow the loudspeaker to be used
in either the horizontal or vertical orientation. DO NOT SUSPEND THE
LOUDSPEAKER FROM FEWER THAN TWO SUSPENSION POINTS!!!
DO NOT HANG THE LOUDSPEAKER FROM THE HANDLE!!!
Bracket Mounting
Noho C and Soho 12 loudspeakers have 4 x 1/4-20 T-nut inserts molded
into the back of the cabinet for use with a multi-position bracket. Berlin
15/H, Cairo 15/C, Chicago 15/12 loudspeakers all feature 4x 3/8-16
threaded inserts on the back of the cabinet for use with multi-position
brackets.
Deployment- AS Series
Troubleshooting
1. No sound from speaker:
A) Make sure that the cabling you are using is wired correctly. The signal
for the full range units must be wired to the “1” pair of contacts on the
cable-mounted Neutrik Speak-On™. For the low frequency units, the
Chicago 15/12 and the 15” LF driver of the Cairo 15/C, the signal must be
connected to the “2” pair of contacts on the Speak-On. See page 7 for
details.
B) Technomad loudspeakers are equipped with fuses for component
protection. Check the fuses to ensure that they are still intact. The fuse
holders are located on the bottom of the loudspeaker in the handle well
on AS Series loudspeakers and on the back of the loudspeakers near the
connectors on MP Series loudspeakers. See the separate fuse sheet
included with this manual for proper fuse values.
2. Excessive Rattling:
If, at high volumes, pronounced rattling occurs double check that the
latches holding the lid onto the rear of the cabinet are fully closed and
locked. If they are not, the lid can vibrate against the back of the cabinet.
Technical Support
For tech support, call your dealer, call 800.464.7757, fax at 617.451.8999,
or send e-mail to
World Wide Web
Visit our Website and get all of the latest info on Technomad loudspeakers .
http://www.technomad.com
• Product Updates
• Dealer and Rep. listings
• QuickTime Movie clips of Technomad loudspeakers being shot
with a shotgun, pummeled with a 20 pound sledge hammer,
thrown from a 45 foot bridge into a river and doused with
gasoline and set aflame!
• Product Specifications
• Press Releases
The Website changes monthly so be sure to always check back for the
latest information.
General Info
9
4
