TS Enclosure 550 User Manual
Rev. 1.
2
TS-ENC550 - 5
Installing the Enclosure
Electrostatic Discharge (ESD) precautions
Before performing any set up or placement procedures, take the precautions outlined in this
section.
i
Important
Be sure to take appropriate Electrostatic Discharge (ESD) precautions.
Disconnect the power cable at the rear panel of the enclosure before moving,
cabling, or performing any set up procedures.
Setup and Installation Instructions
Follow these guidelines for safety and maximum product performance:
Observe local health and safety requirements and guidelines for manual material handling.
Set the enclosure on a level surface with adequate ventilation.
Ensure the rubber feet are used for protection and stability on level surfaces.
Wall-mount the unit if placement on a level surface is not available, or desired.
Setup Tools
Depending on the placement and cabling of the enclosure, you may need the following tools:
Small flat-blade screwdriver
Small Phillips screwdriver
Setup Procedure
After locating, setting up, grounding, and cabling the enclosure:
1.
Apply power to the unit.
The amber-colored LED on the rear panel should be lit.
2.
Monitor COM2 using a terminal emulator to verify that the enclosure is operating
properly.
Disconnecting AC Power
1.
Unplug the power cord from the power source.
2.
Disconnect the power cord from the rear panel of the enclosure.
