2/11/2020
TS-7100 - Technologic Systems Manuals
https://wiki.embeddedarm.com/w/index.php?title=TS-7100&printable=yes
38/44
10.22 WiFi
This board uses an ATWILC3000-MR110CA (http://www.atmel.com/images/atmel-42569-atwilc3000-mr110ca-
ieee802.11bgn-link-controller-with-integrated-bluetooth4.0_datasheet.pdf%7CAtmel) IEEE 802.11 b/g/n Link
Controller Module With Integrated Bluetooth® 4.0. Linux provides support for this module using the wilc3000
driver.
Summary features:
IEEE 802.11 b/g/n RF/PHY/MAC SOC
IEEE 802.11 b/g/n (1x1) for up to 72 Mbps PHY rate
Single spatial stream in 2.4GHz ISM band
Integrated PA and T/R Switch Integrated Chip Antenna
Superior Sensitivity and Range via advanced PHY signal processing
Advanced Equalization and Channel Estimation
Advanced Carrier and Timing Synchronization
Wi-Fi Direct and Soft-AP support
Supports IEEE 802.11 WEP, WPA, and WPA2 Security
Supports China WAPI security
Operating temperature range of -40°C to +85°C
11 Specifications
Note:
This section is incomplete at this time.
11.1 Power Specifications
The TS-7100-Z accepts a range of voltages from 8 V to 28 V DC.
11.2 Power Consumption
11.2.1 TS-SILO SuperCaps
12 External Interfaces
12.1 CN32 Terminal Block
The TS-7100 features a 2x16 IO header. The mating pluggable terminal block with spring clamps from On Shore
(OSTNL321003) is included with the TS-7100. This connector supports AWG 24-16.
To plug in or unplug and individual pin, press and hold in the orange tab near the pin.
To remove the entire terminal block from the connector press the orange tabs on each side down. On plugging it
back in the tabs will flip back up.
