4.
Checking the correct polarization, insert 2 x AAA, IEC LR3, 1.5V batteries into the battery
compartment and replace the cover.
5.
If you have purchased additional outdoor transmitter(s) wait until the outdoor temperature
has been received from the one transmitter before activating the next transmitter by
repeating steps 3 and 4.
6.
However, ensure that you leave 10 seconds in between the reception of the last
transmitter and the set-up of the following transmitter. The Remote Thermo will number the
transmitters in the order of set-up, i.e. the first transmitter will have the temperature
displayed with the number 1 against it and so on.
7. When
the outdoor temperature(s) is received the Remote Thermo and transmitter(s)
should be positioned in the desired places (see
Positioning & securing
below)
Note:
Should the total time of inserting the batteries into the transmitters take longer than 2-1/2 minutes
from the time of inserting the batteries into the Remote Thermo then temperature reception
problems may occur. If the temperature is not received, then see
Checking for 433 MHz
reception
, before resetting the units (see
Resetting the Remote Thermo
below).
23
