AutoGRAPH ON-BOARD CONTROLLER • USER MANUAL
65
TechnoKom © 2016
Connection to PC
Some cases may require connection of the AutoGRAPH controller to a personal computer
(PC) or a laptop. A PC connection may be required for:
•
configuration and checking of the performance of the tracker by means of the configuration
program – AG.GSMConf;
•
using the tracker in the «GPS mouse» mode;
•
reading the data from the tracker storage memory and writing the data directly to the
AutoGRAPH dispatch software.
To connect the tracker to a PC:
•
Disconnect the tracker from the vehicle power supply.
•
Disconnect the antennas and remove the device from the vehicle.
•
Connect the tracker to your PC using a USB cable.
•
If the drivers are installed, the system automatically identifies the controller. If the drivers
are not installed, install them following the steps specified in the «Installing the drivers»
section.
•
The tracker is now ready to operate with the applications.
For detailed information on configuration the tracker using the AG.GSMConf program see
document «Configuration and setup. AG.GSMConf Software».
For more information on reading data from the tracker using the AutoGRAPH 5 PRO Dispatch
Software see «AutoGRAPH 5 PRO Software. User Manual» document.
i
NOTE
i
NOTE
