AutoGRAPH-Mobile • USER MANUAL
15
TechnoKom © 2016
Switching on
Before switching on, insert SIM cards into the tracker and connect the battery.
To switch the tracker on:
• Press the POWER button for a few seconds;
• As soon as the POWER LED turns on, release the button.
• The POWER LED is located above the POWER button.
When the back cover is removed it is easy to see the LED
flashing. If the back cover isn’t removed, the LED can be
seen through the hole intended for the access to the POWER
button.
• Now the tracker is ready to operate.
When switching the tracker off, the second press must be performed while the POWER LED is ON (during
about 3 seconds after the first press). Otherwise, the switch off procedure should be started again. It is
made in order to suspend an accidental switching off of the tracker.
IMPORTANT
For proper operation the tracker must connect to a GSM network and acquire the position.
For the first start, it can take up to 23 seconds to determine the coordinates. The tracker’s
operation is indicated with two LEDs. More detailed information on the indication is given in
the “Tracker’s Indication” section.
Switching off
To switch the tracker off:
• Press the POWER button for a few seconds;
• As soon as the POWER LED turns on, release the button and quickly press it again.
• The POWER LED is located above the POWER button. When the back cover is removed
it is easy to see the LED flashing. If the back cover isn’t removed, the LED can be seen
through the hole intended for intended for the access to the POWER button.
• After the second press the tracker turns off.
The AutoGRAPH-Mobile can be set up to turn on only when the external power supply is connected
(5V). This mode can be used when the tracker is installed in a vehicle and allows to preserve the battery
power.
i
NOTE
