JOG NOW : Service & maintenance manual - rev. 5.1
Page 8.1
8.
ADJUSTMENTS
8.1.
TENSIONING THE TREAD BELT
8.1.1.
T
ENSIONING A NEW TREAD BELT
Figure 8-1
Do not measure the tread belt on the
junction area, in order to keep the
correct value.
1.
After replacing the tread belt, place a tape
measure along the centre of the tread belt and
use a pen to make two reference marks
spaced exactly
1m
apart.
Figure 8-2
2.
Lock down by turns the 2 screws
(a)
until the
distance between the reference marks
increases by
6mm
.
Take care that the roller is always
approximately parallel with the one on
the front, to counteract the tension
exerted by the belt on the roller
bearings.
After completing this procedure, any
further adjustments should be
performed using only the left-hand
alignment screw.
CAUTION: After completing this
procedure, check the centring of the
tread belt as instructed in paragraph:
Summary of Contents for Jog Now Excite+ 500
