technoac Success AG-511N, Technical Description, Operating Instructions

Page: 16 / 29

16
4.8. Sound signals
The sound signals correspond with the specific events and conditions.
«Welcome tune» consists of 9 notes activating by the device switching on via pressing POWER
« » button.
«High» note while pressing CHOICE « » button during the automatic adjustment – the relevant action
took place.
«High» note while pressing MORE « » button — the increase (alteration) of the parameter value (mode).
«Low» note while pressing LESS « » button — the decrease (alteration) of the parameter value (mode).
«Very low» note by pressing one of the buttons LESS / MORE « » - the action is not allowed by the
program.
Double note signal by pressing CHOICE « » button in the “stop” mode – the relevant action took place.
Dual sound signal by pressing START / STOP « » – initiation or shutdown of the oscillation.
Triple note signal by pressing START / STOP « » - the manual interruption of the automatic
adjustment.
Th e sequence of the rising notes ending with the triple note signal – the full cycle of the
automatic adjustment.
Double note sequence («siren») - output current overload.
Sequence of the triple note “alarms” – hardware current safety system activation
Sequence to the quadruple note “alarms” – power supply voltage is unacceptably low.
«Quick» sequence of the similar «high» note — power supply voltage is unacceptably high.
«Farewell phrase» consists of the thee falling notes during manual shutdown of the device by
the pressing POWER « » button.
5. Working with the device
Prior to the “contact” connection it is necessary to make sure that the utility under
examination has no voltage to “earth” and also that there are no works carried out or
scheduled to be conducted which execution can lead to deliberate or accidental contact
with conductive part which is under the voltage;
If the examination of cable under voltage is required one should use “non-contact”
method of connection with the help of the transmitting antenna or induction “clamp”.
Attention
!Make sure that the transmitter is turned off, before connecting it to the electric load.
5.1 Preparatory activities
5.1.1 Remove the battery set by simply pulling up by the handle and
insert 8 power supply elements into it observing the polarity (batteries or
NiMh accumulators). Put the battery set back.
5.1.2 When the transmitter is being turned on, it indicates the type of
power supply. In order to change the type of power supply, you have to
turn on the transmitter holding “
” button.
After that, you can switch the type of power supply by pressing
“ ”and “ ”. You can choose between battery “ ” or accumulator “ ”.
To confirm your choice of power supply type, press start button “ ”.
NOTE: Using the accumulators without corresponding
transmitter setting, may cause their malfunction.
7.1.3 Choose the load type from the options:
- “clips” (connect “output cable” to the connector “OUTPUT” on the back panel); - internal
transmitting inductor «In» (no connections allowed to the “OUTPUT” connector on the back
panel);