3
Call: 1-631-648-7481 or Visit: support.technocnc.com
Plasma User Manual
WinCNC
Website: support.technocnc.com
Tel: 631-648-7481 • Email: [email protected]
PLASMA FORKLIFT GUIDE
II. MEASURING FORKS AND FORKLIFTING MACHINE
2.1
Fig. 2.1
Measuring the distance between the forks.
(shown in Fig 2.1).
NOTE: Forklift capacity must be
adequate to safely lift the machine.
I.
SAFETY
WARNING:
DO NOT LIFT OR
MOVE MACHINE
USING GANTRY
1.1
Be very careful not to damage the wiring and/
or the plumbing underneath the machine.
It is recommended that you have professional riggers conclude the installation if you are uncomfortable with this method.
For safety and to prevent damage to the machine
and cables, Lift Machine Using Forklift Tubes ONLY
Forklift your machine up from the
floor and remove the wooden pallet.
2.2
Fig. 2.2
Take care not to damage the
machine.
Slowly move in close to the
machine.
Front of Machine
Rear of Machine
1
3
2
4
Right Side
Left Side
1
2
4
3
Please note the 4 Forklift Tubes on
the front and rear of the machine.
Fig. 1.1
If required, there are 4 Forklift Tubes
on the sides of the machine.
28"
23"
23"
Summary of Contents for WinCNC
Page 29: ...29 Call 1 631 648 7481 or Visit support technocnc com Plasma User Manual WinCNC...
Page 30: ...30 Call 1 631 648 7481 or Visit support technocnc com Plasma User Manual WinCNC...
Page 31: ...31 Call 1 631 648 7481 or Visit support technocnc com Plasma User Manual WinCNC...
Page 33: ...33 Call 1 631 648 7481 or Visit support technocnc com Plasma User Manual WinCNC...
