TECHNISONIC INDUSTRIES LIMITED
www.til.ca
TFM-550 Installation & Operating Instructions
TiL 99RE262 Rev A Issue 9
2-2
f)
REMOTE BS
- Only used when an RC-550 slave control head is attached.
Setting this feature on will give the transmit selection to the
Band Select switch on the RC-550 rather than on the radio.
This is useful when the operator at the RC-550 is using the
VHF high and low bands. Regardless of whether this feature
is set to on or off, the fourth squelch light will light on both
units when both BS switches are set to the same position.
g)
SIDETONE
- The TX audio circuit becomes active allowing you to adjust
the sidetone level with the VHF volume knob. When the
desired level is reached, press ENTER and this level will be
set for both VHF and UHF bands. The factory setting is 23.
NOTE:
The sidetone level must be set every time you go
through the configuration menu since it takes the setting of
the volume knob regardless of whether you set it or not.
FIGURE 2.1
TFM-550 Operator's Switches and Controls
Summary of Contents for TFM-550
Page 6: ...ii...
