TechniSat DIGITRADIO 585, Instruction Manual

Page: 55 / 364

55
DE
EN
FR
IT
NL
DA
PL
SK
SL
> Close the battery compartment lid carefully again to ensure that the lid
retaining tabs engage in the housing.
To operate the remote control, you will need 2 x alkaline batteries (type Micro,
1.5 V, LR03/AAA). Ensure that the polarity is correct when inserting.
- Promptly change batteries that are losing power.
- Leaking batteries can cause damage to the remote control.
- If the device is not being used for a prolonged period, remove the batteries
from the remote control.
- Important information concerning disposal: batteries can contain toxic
substances which harm the environment. Therefore, it is imperative to
dispose of the batteries according to the legal provisions in force. Never
dispose of batteries in normal household waste.
6.4 General device functionality
Settings and functions can be carried out both using the buttons on the device and
with the remote control. The description of the operation in this instruction manual
refers to the buttons on the remote control.
6.4.1 Switching on the device
> You can use the VOLUME/ knob (2) on the device or On/Standby (1) on
the remote control to switch the device on or back to standby.
After switching on for the first time, you can launch the set-up wizard
(Section 17.7). Here you can set the date and time either via DAB/FM, Internet
or no update (manual). The device will then attempt to establish a connection
to a WLAN network. To do so, select the corresponding WiFi network and, if
required, enter the WiFi password with the remote control.
6.4.2 Switching off the device
> You can use the VOLUME/ knob (2) on the device or On/Standby (1) on
the remote control to switch the device on or back to standby. The date and
time are shown in the display.
6.4.3 Operating the device with the remote control
With the infrared remote control you can operate the most important device
functions from the comfort of your armchair. When operating the device with the
remote control, please take into account the following points:
>
Point the remote control at the front of the device.
> Visual contact between the transmitter and the receiver must be guaranteed.
> If the range of the remote control reduces, replace the batteries by new ones.
The maximum range is approximately 5 metres from the front of the device.