Carefully remove the control board module from the exterior packaging and inspect it
for damaged or missing parts. For a list of parts included in the SoM Replacement Kit,
see Section 1.2.1: SoM Upgrade Kit Contents. The SoM module is packaged in an
antistatic, sealed, zipper storage bag; it should not be opened or the SoM should not
be handled without using the antistatic wrist strap.
Prior to installation, the unit should be stored in its original packaging and protected
from adverse weather conditions and abuse.
If the control board module is damaged or parts are missing, a written report must
be submitted to:
TechnipFMC
c/o Inside Sales Department, Measurement Solutions
PO Box 10428
Erie, PA 16514
1.4 Storage Instructions
To ensure your replacement SoM is not damaged by moisture or water before being
installed, it must be properly stored in a cool, dry, protected location and remain in its
resealable zipper antistatic bag.
1.5 Warnings and Precautions
Before you begin the process to replace the SoM, please read all of the following
warnings and cautions to reduce the risk of injury, equipment damage, or malfunction.
1.5.1 Hazardous Locations
The Ultrasonic Meter Control (UMC) assembly is approved for use in an explosive
environment or hazardous location. This manual only provides information pertaining
to the installation of the SoM replacement.
To maintain equipment safety, it is required to keep the front cover of the enclosure
bolted tightly while power is applied when operating in a hazardous location. The
closing and sealing of the enclosure is the key to maintaining explosion protection. It is
imperative that servicing be performed by a qualified individual who is familiar with
associated risks involved with the operation and maintenance of electrical equipment
in hazardous (classified) locations. This individual must have knowledge of local and
national electrical codes, in addition to ordinances concerned with hazardous location
Bulletin MN0A005 Issue/Rev. 0.0 (4/22)
3
SoM Replacement Manual
