7
Satisfaction guaranteed on all our CNC tooling solutions | www.techniksusa.com
• Choose the toolholder seat that corresponds with your toolholder.
• Place the seat over the pedestal hole and insert your toolholder.
• Choose the induction stop ring that corresponds with your
toolholder.
• Place the stop ring into the induction head, rotate it 90˚ to secure
its position.
• Lower the induction head until there is an a 1/8” gap between the
stop ring and the end of the toolholder.
• From the main screen, select your tool shank size. You can switch
between inch or millimeter using the setup screen.
INSERTING YOUR CUTTING TOOL
• Heating duration is set by default based upon shank size. Use the
gray slider bar on the touch screen to add or subtract time.
• Wearing the insulated glove on one hand, with your other hand,
press and hold the red button located on the induction head.
• After 2–3 seconds attempt to insert the cutting tool into the
toolholder. Continue holding the button until the cutting tool is
successfully inserted into the toolholder. You can stop the heating
cycle at any time by releasing the red button.
HEATING CYCLE
Note: Never allow any part of the induction head
to contact the toolholder or cutting tool during
the heating cycle or damage to the machine may
occur.
REMINDER:
Always inspect your cutting tool for any imperfections on the shank such as chips, burrs, or scarring. If you find any,
do not use that cutting tool in a shrink-fit toolholder, or it may no be able to remove it. The ability to insert and remove tools is
enhanced when cutting tools and holders are dry and clean.
REMINDER:
If the heat cycle ends before the cutting tool can be inserted,
increase the duration by 10%. If the cutting tool is inserted before the
cycle ends, you may reduce the duration for that shank size.
Use the drop
down menu to
choose your
shank size
Touch units to
switch between
inches or metric
OPERATIONS GUIDE
Summary of Contents for 00500 ShrinkPRO Quencher
Page 28: ...28 Phone 800 597 3921 or 317 803 8000 Fax 317 803 8001 MSDS Sheets for CIMTEC Coolant ...
Page 30: ...30 Phone 800 597 3921 or 317 803 8000 Fax 317 803 8001 MSDS Sheets for CIMTEC Coolant ...
Page 32: ...32 Phone 800 597 3921 or 317 803 8000 Fax 317 803 8001 MSDS Sheets for CIMTEC Coolant ...
