Preliminaries
!
Check that the mains voltage on the rating
plate which is located at the rear of the unit
matches the mains voltage in your area.
!
Unwrap the power cord
!
Uncoil the FM antenna and extend it fully.
The system can be used freestanding or wall
mounted
Ensure there is a suitable power point within easy
reach. The mains plug must not be obstructed
and must be freely operable at all times.
Make sure there is a least 150 mm (6”) of free
space above the unit so that the CD door can
open to its full height.
If you are free standing the system, site the system
on a stable surface (ideally a stout shelf) where it
is unlikely to fall or get knocked over.
Make sure that you position the unit where the
remote handset can easily be operated in direct
line of sight and no more than 15 metres away.
The radio performance of the system depends on
the aerial. If you plan to wall mount the unit make
sure that there is adequate signal strength in your
proposed location before drilling the wall.
The FM aerial should be moved around to get the
ENSURE THE WALL IS STABLE AND CAN SUPPORT THE WEIGHT OF THE UNIT. It is for the user to
optimum results.
Do not extend or cut the FM
determine whether the supplied hardware is suitable for the wall and to provide proper alternative
antenna lead.
fixings if not. If you are unsure of how to proceed consult a qualified building expert.
The MW aerial is internal to the system, so if you
Apply the supplied template to the wall and mark the position of the holes. Ensure the template is
need good medium wave reception, try the
horizontal so that the unit sits level. This is most important. Drill two 6mm holes in the wall. Push the
system in different locations before making a final
wall plugs in and screw the two screws in leaving 7mm protruding. Align the keyhole slots in the unit
choice.
over the screws and pull gently down to hang the unit.
SITING AND PLACEMENT
ATTACHING THE TABLE STAND
4
1: Place the unit face
down on a table. Place a
soft cloth under the unit
to avoid damaging it.
2: Align the tabs on the
stand over the slots in
the unit
3: Slide the stand
forward and push the
tabs into place in the
unit.
4: When the tabs click into
place the stand is attached
5: Stand the assembly upright
and check that the stand firmly
supports the unit.
CLICK
WALLMOUNTING THE SYSTEM
