Technics ST-GT1000, Service Manual

Page: 16 / 64

ANNOUNCEMENT
CANCEL
ANNOUNCEMENT
A
B
TEXT
1
2
MENU
MENU
ENTER
MENU
ENTER
MENU
3
MENU
4
Using announcement services
A
While listening to DAB
Press and hold [-ANNOUNCEMENT –CANCEL] for
about two seconds.
The “ANNOUNCEMENT” indicator lights and the unit is ready to
receive announcement services.
When an announcement service you turned on in the settings steps
is received, the unit automatically plays that announcement (
a
The “ANNOUNCEMENT” indicator flashes.
To cancel
Press and hold [-ANNOUNCEMENT –CANCEL] for about two sec-
onds so the “ANNOUNCEMENT” indicator goes out.
This function is also canceled when the unit is turned off.
Returning to normal programming during an announce-
ment
Press [-ANNOUNCEMENT –CANCEL].
Normal programming is played until an announcement starts.
Alarm announcements start as soon as you tune to a station, but it
takes about 10 seconds for other announcements to start.
Irrespective of any settings you made, the unit will be compelled
to switch to some alarm announcements.
Announcements that do not have a language signal attached to
them may be played irrespective of language settings.
Cancel the announcement function if you are recording a pro-
gram.
Note
DAB tuning is usually done in blocks (e.g., 13A), but if necessary it
can be done in 16 kHz steps.
Perform these steps within about 30 seconds of each other.
While listening to DAB
Press [MENU].
Press [+] twice to display “TUNING STEP”
and press [ENTER].
Press [–] or [+] so “16 kHz” flashes and press
[ENTER].
Press [MENU].
The previous display is restored.
To restore the previous step
Select “BLOCK” in step 3 and press [ENTER].
4
3
2
1
Changing the tuning step
B
1 1 1 4
a
).
T
T
T
T
2 3