Technics ST-C700, Owner'S Manual

Page: 22 / 36

22
Occasionally, Panasonic may release updated firmware for
this unit that may add or improve the way a feature operates.
These updates are available free of charge.
Preparation
≥
Connect this unit to the network. ( > 12)
– Make sure that the network is connected to the Internet.
1
Press [NWP].
2
Press [HOME].
3
Press [ 3 , 4 ] repeatedly to select “SETUP”
and then press [OK].
4
Press [
3
,
4
] repeatedly to select “F/W
Update” and then press [OK].
5
Press [
3
,
4
] to select “Yes” and then press
[OK].
≥ When the update has finished successfully, “Success” is
displayed.
6
Disconnect the AC power supply cord and
reconnect it after 3 minutes.
≥ If there are no updates, “No Need” is displayed after step 5.
≥
Downloading will require several minutes. It may take longer or
may not work properly depending on the connection environment.
∫
Checking the firmware version
1 Press [NWP].
2 Press [HOME].
3 Press [
3
,
4
] repeatedly to select “SETUP” and then
press [OK].
4 Press [
3
,
4
] repeatedly to select “F/W Version” and
then press [OK].
≥ Press [OK] to exit.
When other equipment responds to the supplied remote
control, change the remote control code.
≥
The factory default is “Mode 1”.
Point the remote control at this unit, and press
and hold [OK] and the numeric button for at least
4 seconds.
≥ When the remote control code is changed, the new code
will appear on the display for a few seconds.
≥
When the SU-C700/SL-C700 is connected via the system control
function, change its remote control code as well as the remote
control code for this unit.
You can change the character encoding of track names,
artist names and other information when they are not
displayed as they should be.
≥
The factory default is “Type 1(
日本
)”.
1
Press [NWP].
2
Press [HOME].
3
Press [ 3 , 4 ] repeatedly to select “SETUP”
and then press [OK].
4
Press [ 3 , 4 ] repeatedly to select “E Asian
Character” and then press [OK].
5
Press [ 3 , 4 ] to select
“Type 1(
日本
)”/“Type 2(
简体字
)” and then
press [OK].
Firmware updates
Do not disconnect the AC power supply cord or lower
the power switch lever to the [OFF] position while one
of the following messages is displayed.
“Linking” or “Updating”
≥ During the update process, no other operations can be
performed.
Remote control code
[OK] + [1] Set the code to “Mode 1”
[OK] + [2] Set the code to “Mode 2”
Changing the character
encoding
Type 1( 日本 )
Priority is given to Japanese.
Type 2(
简体字
)
Priority is given to Chinese
(Simplified).
ST-C700-SQT0495_PP_mst.book 22 ページ ２０１５年１月７日 水曜日 午前１０時３６分