Technics SH-1000R, Operating Instructions Manual

Page: 16 / 104

06
English
(16)
Mounting on the turntable base
Putting the player together
(continued)
1
Tighten the detachable handle
screws supplied with SP-10R into the
detachable handle mounting holes
(at two locations) on the SP-10R
main unit.
4
Place one packing cushion under the
main unit to put it at an angle to
tighten the screw set for SP-10R using
the accessory hex wrench.
(The two locations indicated in the
figure right)

Attach the screw, washer and belleville spring
in the order as shown below.
Detachable handle
mounting hole
Protective sheets
Screws
The attaching order
Attention
 Tighten the detachable handle by turning it 5 or
more times. If you have tightened it until the end,
loose a little bit. Do not tighten it firmly.
3
Remove the insulators.
 Place two packing cushions under the main
unit to lift it, and turn the insulators counter-
clockwise (to the left hand) when seen from
below.
Packing cushion
2
Slowly lift the SP-10R main unit and
place it on the turntable base.
 Be careful not to catch the control unit
connection cable.
Pass the control unit connection cable
through the hole on the turntable base.
Detachable
handle
Washers
Belleville
springs