Page
15
/
27
Installation procedure for connecting to the Ethernet interface
Follow these steps for proper installation. Plug the coaxial cable to the cable wall outlet and the other end to
the modem connector labeled "CABLE".
Note:
To
ensure
a
fast
registration
of
the
modem,
the
coaxial
cable
must
be
connected
to
the
modem
before
it
is
powered
on.
Plug the power supply into the socket of the cable modem and two-pin on the adatper plug into the AC outlet.
Note:
Only
use
the
power
supply
that
comes
with
the
modem.
Using
another
power
supply
can
cause
damage
to
the
product,
and
will
void
the
warranty.
Connect an Ethernet cable (direct connection, see below) to the Ethernet port at the back of the computer,
and the other end to the ETHERNET port on the rear panel of the cable modem. The modem will seek the
appropriate cable signal on the cable television network and go through the initial registration process on its
own. The modem is ready for data transfer after the green LED "ONLINE" is lit continuously.
Note:
the
button
"reset"
at
the
back
of
the
modem
is
used
primarily
for
maintenance.
Fig. 1-7 Connect to the Modem
