The
RX38Ur
is designed to power up to two full-range passive loudspeakers,three surround speakers and
one subwoofer. The speakers should be connected via the speaker wire outputs on the rear of the
RX38Ur
.
Connecting the RX38Ur to Passive Loudspeakers
AC Power Cord Connection
To connect the power cord to your RX38Ur simply plug female side of the power cord into the power
cord input which is on the rear of the RX38Ur. Then plug the male side of the power cord to an
electric outlet.The AC power cords supplied purposefully have 2 blades and one grounding prong. If
your outlet is not equipped to handle this type of plug,do not attempt to forcefully plug this AC power
cord into the outlet, and do not alter the plug so that it can fit in the outlet. The only course of action
you can take is to find another outlet which is properly equipped to handler a grounded plug or have
an electrician upgrade your electrical outlet. Be sure that the plug is well connected so that it does
not disconnect in the middle of usage. If at any point in time the supplied AC power cord is punctured
or damaged replace it with a new power cord from a local electrician.
NOTE: ONLY PLUG IN THE AC POWER CORD WHILE THE UNIT’S POWER IS OFF AND THE
VOLUME IS TURNED DOWN. TURNING ON THE UNIT WITH THE VOLUME TURNED UP MAY
CAUSE THE UNIT OR ANY SPEAKERS CONNECTED TO IT TO BE DAMAGED. ALWAYS TURN
DOWN THE VOLUME PRIOR TO TURNING OFF THE UNIT.
Input / Output Connections
Connecting the Signal Source to the RX38Ur(DVD/MIXER/MP3 etc.)
NOTE: BE SURE NOT TO CONNECT AN AMPLIFIER OR ANY AMPLIFIER SIGNAL INTO THE
RCA INPUT JACK. AS THIS COULD DAMAGE THE RX38Ur. NO OTHER AMPLIFIER IS NEEDED
TO POWER YOUR SIGNAL IN ADDITION TO THE RX38Ur. ALWAYS MAKE SURE THAT THERE
IS ONLY ONE AMPLIFIER IN THE SIGNAL PATH.
There are also input jacks for a MP3 player,USB flash drive and SD card on the front panel of the
RX38Ur which is compatible with iPod™(Classic and Nano) via the USB input. Just plug the MP3
player,USB flash driver,SD card or iPod™(Classic and Nano) into their respective input jacks and set
the RX38Ur to the corresponding input. Be sure that the volume of your MP3 player and RX38Ur are
turned down at first and then slowly raise the volume to prevent damage the speakers or any of your
other equipment.
The RX38Ur has two RCA input jacks on the rear of the unit which is designed to receive the signal
directly from your DVD,mixer or any of your other 2 Channel signal sources. To ensure that you have
correctly connected your DVD player (other sound sources) to the unit,make sure that the DVD player
has a RCA cord coming from its output and that this cord is plugging into the RCA Input on the rear of
the RX38Ur. Ensure that the polarity of your signalis always maintained by using color coordinated
RCA cables.
NOTE: WHEN MAKING THESE CONNECTIONS THE POWER OF THE
RX38Ur
AND THE SIGNAL
SOURCE SHOULD ALL BE IN THE OFF POSITION WITH THE VOLUME LEVELS TURNED DOWN.
ONCE
THE UNITS ARE ALL POWERED ON, SLOWLY INCREASE THE VOLUME TO AVOID DAMAGING ANY
OF YOUR EQUIPMENT. THE RX38Ur OPERATED MOST EFFICIENTLY WHEN USED WITH 8 OHM
SPEAKERS.
RX38Ur
