PK15BT
5
Troubleshooting:
SYMPTOM
POSSIBLE CAUSES
REMEDIES
No power
The power cord is not plugged in
The power switch is set to the OFF position
Plug the power cord into an outlet
Set the main power to the ON position
No sound
The master volume control is set to the zero
position
The 1/8” AUX/RCA wires are not connected
securely
The input selector is set to the wrong input
Turn the volume control in the clockwise
direction
Connect the wires securely
Switch the input selector to the correct setting
The mic input isn’t
coming out of the
speakers
The wired mic is not plugged in securely
The wired mic is plugged into the guitar input
instead of the mic input
The mic volume is set to zero
Securely plug in the wired mic
Plug the mic cord into the mic input port
Increase the mic volume to the desired level
Mic output is being
drowned out by the
music
The mic output volume is too low relative to
other inputs
Set mic priority to ON
Increase mic volume relative to master
volume
The guitar input isn’t
coming out of the
speaker
The guitar input cord isn’t securely plugged in
The guitar cord is plugged into the mic input
port
Guitar volume is set to zero
Securely plug the guitar cord into the guitar
input port.
Remove the guitar cord from the mic input
port and insert it into the guitar input port
Increase guitar volume
Audio needs
adjusting
The bass or treble knobs are set incorrectly
The wrong digital equalization mode has been
selected
Adjust the bass and treble knobs to the desired
setting
Select a digital equalization mode that better
fits the music needs
DISCLAIMER!
This device complies with part 15 of FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) this
device must accept any interference received, including interference that may cause undesired operation.
Federal Communications Commission Requirements: The equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to part
15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Increase the separation between equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
The changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FCC Radiation Exposure Statement: The equipment complies with FCC radiation exposure limits set forth for uncontrolled equipment and meets the FCC radio
frequency (RF) Exposure Guidelines in Supplement C to OET65. The Equipment has very low levels of RF energy that it is deemed to comply without testing of
specific absoprtion ratio (SAR).
The Bluetooth word mark and logos are registered trademarks owned by SIG, Inc. and any use of such marks by Technical Pro is under license. Other
trademarks and trade names are those of their respective owners.
