Technica Engineering USB-100BASE-T1, User Manual, Page: 16 / 23

USB-100BASE-T1 Converter  User Manual 16
Please wait for version 1.5 coming soon!!
You can close the window by clicking on the “x”, you can then find it again in the
system tray:
Figure 4-3 Device Settings in Master / Slave
4.1 NIC settings (information)
1) Network Interface Card (NIC) Set Up:
For the USB 100Base T1 device the NIC of the PC the default mode for the
device speed on the USB-
LAN side is “Auto Negotiation”.
The 100BASE-T1 phy is always only set to 100 Mbps full duplex.
If desired, the user can follow these steps change USB-LAN NIC from auto
negotiation to 100Mbps Full Duplex.
However, it must be noted, that these might have no influence at all in the
functionality of the device.
i. Go to Control Panel > Hardware and Sound > Device Manager
ii. In the Device Manager Click on Network adapters > Right Click on
LAN9500A USB 2.0 to Ethernet 10/100 Adapter > Properties