Technibel PORTABLE SCDF32C5I, Operating Instructions Manual

Page: 6 / 84

6
EN
OPERATION WITH THE REmOTE CONTROL UNIT
When using the remote control unit, always point the unit
transmitter head directly at the air conditioner receiver.
TEmPERATURE SENSOR SELECTOR
•
Under normal conditions the room temperature is
detected and checked by the temperature sensor placed
in the remote controller (I FEEL icon displayed ).This
function is designed to provide a comfortable room
temperature by transmitting the temperature control
command from the location next to you. When using this
function, the remote, control should always be pointed
at the air conditioner, therefore it should be placed in
a position in which it is visible by the indoor unit (for
example, do not put it in a drawer).
l
It is possible to disable the remote controller room
sensor pressing the I FEEL button. In this case the I
FEEL icon on the remote controller display lights off and
the sensor placed in the air conditioner becomes active.
USING THE REmOTE CONTROL UNIT
INDOOR UNIT
REMOTE CONTROL UNIT
RECEIVER
TRANSMITTER HEAD
• Insert two AAA alkaline batteries of 1,5 V-DC making
sure that point in the direction marked in the battery
compartment.The displayed time flashes.
Press the SEL TYPE button.
Remote controller is now ready for operation.
• The batteries last about six months. Depending on how
much you use the remote control unit.
Remove the batteries if you do not use the remote
control unit for more than one month.
Replace the batteries when the remote control unit
lamp fails to light, or when the air conditioner does not
receive the remote control unit signals.
• The batteries of the remote control contain polluted
substances exhausted batteries must be disposed
according to the laws in force.
HOW TO REmOvE BATTERIES
• Remove the lid.
• Press the battery
t o w a r d t h e
n e g a t i v e e n d
and lift it out by
its positive end
(as shown in the
figure).
• Remove the other
battery in the same
way.
HOW TO INSTALL BATTERIES
• Remove trhe lid in the rear part of the remote control
unit and check the settings of the microswitches as
shown below:
SWITCHES
The remote control unit transmits signals to the
indoor unit each time you press a key and at any
temperature change detected by the IfEEL sensor. In
case of troubles (low batteries, remote control placed
in a position not visible by the indoor unit,...) room
temperature control is automatically switched to the
sensor of the indoor unit. In this case, the temperature
around the remote control unit may differ from the
temperature detected in the air conditioner position.
NOTE