10
• Wall mounting:
- Secure the unit at a height of approximately 1.5 m from the floor in a location representative of normal convection
currents, while avoiding:
- wall which are poorly insulated or liable to vibrate,
- the proximity of parasitic heat sources (sunshine, heating appliances, lamps, fireplaces, televisions, etc.),
- currents of air from doors or windows,
- sheltered locations such as shelves or behind curtains,
- near electrical outlets.
- For manual control K 60 D 076 Z, check and modify as required the ventilation selection jumper connection SR
depending on the appliance (see below).
- For the K 60 D 025 Z automatic control, if necessary, adjust the neutral zone using the potentiometer located inside
the control.
• Do not install in a local where there is a risk of condensation or water projection (max. relative humidity:
95%).
• Caution:
If a remote control is used, remove the wire between terminal L1 and switch S1 on the air processor terminal
board.
5.5.2 - CONNECTIONS WITH "RAB 30" MANUAL REMOTE CONTROL - Code K 60 D 076 Z
Operating switch
with fan speed selection
Heating / cooling selector switch
K 60 D 076 Z
L
Y1
Q3
Q2
Q1
SR2
SR1
SR
Auto
Y2
TAV
U1
2
1
N1
3
4
6
5.5.3 - CONNECTIONS WITH AUTOMATIC REMOTE CONTROL - Code K 60 D 025 Z
K 60 D 025 Z
1
N
2
22
21
20
6
TAV
11
12
U1
2
1
N1
3
4
6
Phase
Neutral
HS
MS
LS
Cooling
Heating
Air temperature sensor
(if used)
K 60 D 028 Z or K 60 D 033 Z
S1 On/Off switch.
B1 Thermostat.
B2 Hygrostat (dehumidification threshold).
5.5.4 - CONNECTIONS WITH HYGRO-THERMOSTAT - Code K 60 D 047 Z
B1
S1
B2
Temperature setting knob
Phase
Neutral
HS
MS
LS
Cooling
Heating
Position of the SR bridge located inside the controller:
- on SR1
= Permanent ventilation.
- on SR2 (Auto) = Ventilation activated when the thermostat
is in demand.
This position is not accessible with a
heating kit.
On/Off switch
Fan speed selector
Temperature setting knob
