CHAIR’S FUNCTIONS
WARNINGS
CARE AND MAINTENANCE
•
Chairs’ height: Pull UP the lever under the seat. The chair goes down while sitting on it, or up if
you lift your body.
•
Seat tilting: Pull the same lever OUT horizontally to unlock this function, and IN to lock again.
NOTE: Unlike regular office chairs, the racing/gaming chairs have their base components off-
center, and the tilting won’t be much and might actually feel hard to tilt.
•
Tilt tension: Turn the mechanism’s knob in either direction to apply more or less tension. With
less tension, the tilting will feel easier. Please read the above note about the tilting.
•
Backrest reclining: pull UP the lever located on the rear right side of the seat and release it
when the desired position is reached.
WARNING
: For your safety, the seat’s tilt function
should be in the LOCKED (IN) position prior to use the backrest reclining function.
•
Armrest height: Pull UP the button that is under the armrest. Some models have additional
functions like forward/back, in-out, and pivot.
• Do not exceed the indicated weight limit.
• Do not stand up on the chair or use it as ladder.
• Only one person at a time can sit on the chair.
• Do not use the chair if parts are damaged or if screws are loose or missing.
• This chair has the base components off-center than regular chairs. Do not sit near the edge of the
seat to avoid going beyond your balance point and falling off the chair, and always sit properly.
• If small children are sitting on the chair, please keep close observation on them.
• Do not allow small children to play with the chair.
• Not paying attention to these warnings could result in injuries.
•
To clean the chair it is recommended to use a soft cloth lightly damped in a solution of smooth
soap and water, then dry with a clean towel.
•
Do not use solvents or abrasive materials to clean any part of the chair.
•
Before applying a cleaning agent, test on a small hidden area of the chair, like underneath the
seat.
•
Do not expose the product to direct sunlight or to extreme environmental conditions.
•
Every 4 months, inspect the chair completely and make sure that all screws are tighten.
4
3
2
1
5
2
3
2
1
4
5
Weight
Limit
Models
250
Lbs
TS43
TS70
TS90
TS92
TSF44
TSF71
300
Lbs
TS51
TS52
TS83
TS84
TS85
400
Lbs
TSXXL2
P.5
TS43, TS51, TS52, TS70, TS83, TS84, TS85, TS90,
TS92, TSF44, TSF71, TSXXL2
P.5