TEP-1560-BSW HARDWARE MANUAL
– VER 1.00 MAR 25 2019
Page
15
of
39
3.13. Power Input Connector
The TEP-1560-BSW can be powered either over the DC INPUT connector or PoE (optional) over the
RJ45 LAN1 port.
NOTE: Do not power the unit by DC input when you apply power over the Power over Ethernet (RJ45)!
Pin #
Signal
Description
1
GND
Ground
2
VCC
DC Voltage input (12V/24V/8~36VDC)
Header on TEP-1560-BSW: Molex 43045-0200 (2-pin Micro-Fit 3.0).
Cable receptacle: Molex 43025-0200 (2-pin Micro-Fit 3.0) plug with crimp contact Molex 43030-0007.
3.14. Antenna Holes
There are six antenna holes available (two each on the left side, on the right side and on the top side).
They come fitted with breakaway metal tabs. In order to utilize them, the tabs must be removed by
carefully using pincers or pliers.
3.15. Galvanic Isolated Connectors (TEP1560-xxxxx-Rxx-Lxxx-
XG21
-xxxx-xxx-
xxxx-xxxx) (optional)
This product is available with three optional connectors: GPIO1, GPIO2, and RS-XXX that can be ordered
in either galvanic isolated or non-galvanic isolated versions. The TEP1560-xxxxx-Rxx-Lxxx-
XG21
-xxxx-
xxx-xxxx-xxxx has three optional galvanic isolated connectors: GPIO1, GPIO2, and RS-XXX.
Bottom view of the galvanic isolated I/0 Expansion module (TXR-I2-GS2-GG8):
B
A
No.
Description
No.
Description
A
SW1 DIP switch
B
SW3 Terminator Resistor DIP switch
