Use of the device
Charging
Before first use, connect the USB port of the charging cable to the
TX-112. Then connect the USB port of the charging cable to the
USB port of an AC adapter (*not included) or to the USB port of a
computer. During charging the yellow LED is flashing. When it is
fully charged, yellow LED will steady on.
Internal storage
Since the TX-112 uses a built-in memory card (MicroSD), it is not
recommended to remove or replace other memory cards.
Voice recording
Set operation switch to position 1, long press power key, blue LED
will turn on and TX-112 is in standby mode. Short press power key,
the blue LED turns off and yellow LED flashing 3 times. Camera
enters into voice recording mode. Short press power key again, the
voice will be saved and TX-112 will go into standby mode.
Video recording
Set operation switch to position 2, long press power key, yellow
LED will turn on and TX-112 is in standby mode. Short press power
key, the yellow LED turns off and blue LED flashing 3 times.
Camera enters into video recording mode. Short press power key
again, the video will be saved and TX-112 will go into standby mode.
Note:
Maximum file length of video recording is 10minutes, after
that a new file is created. After 1 minute without any operation
(standby) the camera will automatically power off.
Recording while charging
5 seconds after connecting to the adapter or a computer USB,
same operation like normal using.
