5
7. The camera that should be connected will be found automatically. If you have more
than one camera in your network you can select the device from the menu next to the
device name or scan for devices with the button “Scan”.
8. Press “Next”
9. Enter a new camera password. (For safety use a password with minimum of 6
character)
10. Press “Next”
11. Enter camera name. (Camera name can be customized like office, hall, garden, etc.)
12. Press “Next”
13. Shows the device name that is going to be configured.
14. Press “Finish” the device will be configured. After the TX-55 is set up the Ready LED
turns off and reboots the camera. Status LED flashing in Red within 10 sec. Then both
the Ready and Status LED are on. If the configuration couldn’t finished press “Retry”
or start the configuration again. The camera is ready for monitoring from your mobile
device when camera is online.
Note:
1. If the assigned WiFi network of the camera has changed, the camera must use the AP
Mode to set the new assigned WiFi network again.
2. Make sure the assigned WiFi has enough bandwidth otherwise the camera is hard to
reach or needs longer waiting time to access the internet.
