10
Model: TX-214,TX-215; Article No. 5023,5024; 10/2022
15 minutes, and keep cycling.
[C2n] - the load will work for 2 hours at night, stop for 15
minutes, and keep cycling. Setting method: same as above.
NOTE:
1. No matter what kind of load operating mode is set, when the
battery is discharged to as low as the cut-off voltage, the
controller will force to shut down the load.
2. When the controller is in an activated condition, the load will
remain off.
Display current controller temperature
Display the charge current
Display the load current
Boost charge voltage
- regulation interface
(only valid for b04, b07)
When the battery voltage rises to this set voltage, PWM
charging is enabled.
During normal charging, the arrow indicator is always on, and
after entering float charging, the arrow indicator is slowly
flashing.
Setting recommendation: It is recommended to keep the
default value.
Setting method:
same as above.
Over discharge recovery voltage
- regulation interface
(LVR)
When the controller turns off the load due to low voltage, the
load will not be turned on until the battery voltage rises to the
set voltage again.
Setting recommendation: It is recommended to keep the
default value.
Setting method:
same as above.
