Technaxx Digital Converter for LP and Cassettewith built-in Stereo Radio TX–22 User Manual Download Page 6

9. PHONES OUTPUT / EARPHONE JACK 

(9.1.) The device can be connected to amplifier or speakers by 3.5mm HEADPHONE 
jack. 
 
(9.2.) Private listen of earphone also can be realized through this jack. 
 

10. HOW TO REPLACE THE NEEDLE 

(10.1.) Removing the needle from the cartridge: Place a screwdriver at the tip of 
the  needle  heads  hell  and  push  downwards  in  the  direction  shown  in  sketch  “A”. 
Remove the needle head shell by pulling it forwards and pushing downwards. 
 
(10.2.)  Inserting  the  needle:  Hold  the  tip  of  the  needle  head  shell  and  insert  it  by 
pressing in the direction illustrated by “B”. Push the needle head shell upwards in the 
direction illustrated by “C” until the needle locks into the tip position. 

 
 
 
 
 
 
 
 
 
 
 
 

11. TIPS FOR BETTER PERFORMANCE 

(11.1.) When opening or closing the turntable cover, handle it gently, moving it either 
at the center or equally from both sides. 
 
(11.2.) Do not touch the stylus tip with your fingers; avoid bumping the stylus on the 
turntable mat or a record’s edge. 
 
(11.3.) Clean the stylus tip frequently, using a soft brush with a back-to-front motion 
only. If you use a stylus cleaning fluid, use it very sparingly. Wipe the dust cover and 
turntable housing gently with a soft cloth. Use only a small amount of mild detergent 
solution  to  clean  the  turntable  and  dust  cover.  Never  apply  harsh  chemicals  or 
solvents to any part of the turntable system. 
 
(11.4.) Prior to moving the turntable, always unplug it from the AC outlet and fasten 
the tone arm on the tone arm rest with the vinyl twist-tie. 
 
 

 

 

Guide Pins (inside) 

Summary of Contents for Digital Converter for LP and Cassettewith built-in Stereo Radio TX–22








Reviews: