background image

Technaxx

®

   

Digital Converter for LP and Cassette 

with built-in Stereo Radio TX–22 

User Manual 

Declaration of Conformity is under: www.technaxx.de/ (in bottom bar “Konformitätserklärung”) 

Before using the device the first time, read the user manual carefully.

         

 

Before usage 

  Choose  the  installation  location  of  your  unit  carefully.  Avoid  placing  it  in  direct 

sunlight or close to a source of heat. Also avoid locations subject to vibrations and 
excessive dust, heat, cold or moisture.   

  Do  not  install  the  unit  in  a  inclined  position,  It  is  designed  to  be  operated  in  a 

horizontal position only.   

  If  the  unit  is  brought  directly  from  a  cold  to  a  warm  location,  moisture  may 

condense inside the player, and cause damage it. When you first install the unit, or 
when you move it from a cold to a warm location, wait for 30 minutes before operating 
the unit.   

  The  ventilation  holes  should  not  be  covered.  Make  sure  there  is  enough  space 

above and beside the amplifier/receiver. Do not place a CD player or other equipment 
on top of the device. 

 Do not open the cabinet. This might cause a damage to circuitry or electrical shock. 
 When removing the power plug, never yank the cord. If you are not going to use 

the player for long time, be sure do disconnect the player from the AC power source. 

 To prevent fire or shock hazard, disconnect your unit from the AC power source 

when  cleaning.  Use  caution  when  cleaning  and  wiping  the  plastic  parts.  Do  not 
attempt to clean the unit with the chemical solvents as this might damage the finish.   
 

1. FEATURES 

 

Directly recording of LPs, cassettes, radio or from AUX–IN on USB flash drive or 

SD card (up to 32GB) 

 

No PC required

 

 

Plays MP3 music from USB flash drive or SD / MMC card 

 

Analog AM / FM / FM stereo radio 

 

Record player with 3-speeds: 33 1/3, 45, 78 RPM 

 AUX–IN jack and headphone jack 
 Built-in full range stereo speakers 

 

Built-in cassette player 

 

Nice shape and easy handling 

 

 

 

 

 
 
 

Summary of Contents for Digital Converter for LP and Cassettewith built-in Stereo Radio TX–22








Reviews: