13
12
CLEANING TEETH WITH CLEANY TEETH
1. Turn on the unit (press the ON switch
twice in rapid succession in order to
activate silent vibration-free mode);
one click = vibration-mode
two clicks = silent mode
2. Disinfection and moistening
of the brush head and neck
To disinfect the brush, switch on the
device and rinse under slowly running
water for about 3 seconds. Ultrasound
has a disinfecting effect.
3. Use ultrasound tooth brush gel
Apply about one centimeter/half-inch
of the ultrasound toothbrush gel to the
brush head. The special ultrasound gel
supports ultrasound by forming billions
of tiny bubbles that destroy and
remove bacteria with other deposits.
4. Distribute gel onto tooth surfaces
(front, back and chewing surface)
before you start the actual cleaning.
Cleaning times:
2-3 seconds per tooth
surface.
Areas with a lot of tartar or
inflamed gums require
extended time to clean.
Extend cleaning to 5-6
seconds.
3
4
5
5. Tooth Cleaning
With the device running, place the
brush head on each tooth surface for
2-3 seconds to clean them (front and
back, chewing surface), then move to
the next tooth. Do not apply pressure
to the teeth with the brush head.
You should moisten the brush head or
the dog’s mouth, because water assists
the transmission of ultrasound.
Repeat the steps until all teeth have
been cleaned. If you want to brush,
that is no problem. With a single brush
head you will be able to finish in 60
seconds and with a three-sided brush
head in 30 seconds.
Foam between the bristles is perfect
for ultrasound transmission and thus
for cleaning results.
Cleaning the tongue: Simply place the
brush head in the centre of the tongue
for 3 seconds.
6. Rinse, disinfect and
switch off the device.
After cleaning, give the dog some wa-
ter to drink. To disinfect your the brush,
hold brush head under slowly running
water for 3 seconds with the device
running. Then switch off the unit.
2
1
Quickstart ››
6
