LASER MEASURING
(1)
Press the MEAS button (2) to activate the device. Both the LCD
screen and the beam will turn on.
(2)
Press the UNIT button (1) to select your measure plan: distance,
volume or area.
(3)
Press the MEAS button again (2) to trigger the distance
measurement. You can choose your measurement position
accordingly: level, vertical or diagonal line.
(4)
Measurement value will display immediately on LCD screen
(laser point will blink while measuring) Start a new
measurement by pressing the button again and re-activate the
laser beam, then repeat the above step (3).
(5)
Short press the UNIT button (1) (about 1 second) to switch the
distance/volume/area. Long press the UNIT button (1) (about 3
seconds) to switch the metric/inch.
(6)
Press MEAS (2) and UNIT (1) buttons simultaneously to
change the base line: front or back.
(7)
Long press the MEAS (2) button (about 5 seconds) to power off
the device.
Note:
the laser beam and the device turn off automatically after 30
seconds (beam) and 3 minutes (device) respectively to save the
battery. Press again the MEAS (2) button to reactivate it.
MEASURING BLADE USE
(1)
Hold the case with one hand and pull the blade with your other
hand. The blade hangs automatically.
(2)
Press the push button (5) to release the locking system and
complete the blade rolling-up.
Note:
when rolling-up, always accompany the blade to avoid any
danger of injury or damage.
Summary of Contents for AL0519
Page 1: ......
