HDMI EXTENDER OVER CAT.6/7 CABLE 40M
EN
HDMI EXTENDER OVER CAT.6/7 CABLE 40M
10
EN
connEctIons
1) Plug the transmitter unit to the HDMI output port of the source device directly, and plug the
receiver to the HDMI input port of the display device directly.
2) Connect transmitter unit (TX) and receiver unit (RX) via network cables (CAT6/CAT6A/CAT7)
3) Connect the USB cable to the transmitter unit only, each unit will be powered up, this HDMI
extender works
NOTE:
It is recommended to use a length range within 15~40m network cable. If the Cat.6 cable is
too short, there may be no display output because of the signal is too strong. If the Cat.6 cable is too
long, the output may be with poor quality.
FaQ
Q:
No image output or audio and video display is not normal.
A:
1) Press Receiver “LENGTH” button for adjusting this unit to self –adapt to the length of network
cable.
Q:
No image output.
1) Make sure network cable connection follows the standard of EIA- 568B.
2) Check and make sure there is HDMI signal input to the transmitter.
3) Press receiver “LENGTH” button to adjust this unit to self-adapt to the length of network cable.
4) Make sure HDMI cable is well connected with TV.
5) Make sure the network cable is fine copper wires.
Summary of Contents for IDATA EXT-E70S
Page 12: ...www techly com ...
