HDMI 2.0 EXTENDER OVER CAT.6/7 CABLE 4K
13
EN
Ir usEr guIdE
1) IR blaster extension cable should plug in the IR OUT port of TX (Sender) of HDMI extender and the
IR receiver extension cable should in the IR IN port of the RX (Receiver) of this HDMI Extender.
2) The emitter of the IR blaster should as close as possible to the IR receiver window of the signal
source device.
3) Using the IR remote controller of the signal source device towards the IR receiver (connected to
the receiver), to remote control source media playback.
FaQ
Q:
There is no output on screen when all connections are correct?
A:
1) Please check and make sure the display/monitor supports the HDMI signal which fed out
from the source device.
2) Please make sure the HDMI cables supports 4Kx2K if the output signal from the source device
is 4Kx2K resolution.
3) Please check and make sure the network cable insert to the RJ45 port well.
4) Restart the transmitter or receiver by pressing the reset button.
Q:
Black screen happened on the display/monitor?
A:
1) Please check and make sure the length of the network cable within the usable range:
CAT6 within 50m@4Kx2K@30Hz
CAT6 within 30m@4Kx2K@60Hz.
2) Reset the transmitter unit for re-built the connection.
Q:
The color comes abnormity or there is no audio output?
A:
Reset the transmitter unit for re-built the connection.
Summary of Contents for IDATA EXT-E704K2
Page 16: ...www techly com ...
