12
TL-CAV-01-HDV User Manual
www.tlnetworx.com
4.
System Operation
4.1
IR Learning Function
IR learning function allows user to use the buttons of Control Panel to control the
display. The Control Panel has four buttons:
“ON”
,
“OFF”
,
“HDMI”
, and
“VGA”
.
“HDMI”
and
“VGA”
do not support the IR learning function, because they are designed for
switching the HDMI signal sources.
l
Setup Procedure:
1.
Long-press the button
“HDMI”
until the buttons
“ON”
and
“OFF”
light up,
and then release
“HDMI”.
The blue backlight of
“HDMI”
will go out to enter
IR learning mode.
2.
Press the button
“ON”
to enter IR learning status, and it will keep blinking
blue.
3.
Press the corresponding button (such as the “On” button) on IR remote,
meanwhile, put IR remote close to the IR sensor of Control Panel.
4.
Once user set up successfully, the button
“ON”
will stop blinking
5.
Next, repeat the above steps to set another button
“OFF”
.
6.
Finally, Long-press the button
“VGA”
to exit programming mode.
l
Operating Procedure:
1.
Press the button “
ON
” to turn on the display.
2.
Press the button “
OFF
” to turn off the display.
&
²
When the system enters IR learning status, long-press the
“VGA”
button for
more than 5 seconds to exit.
²
If there is no interaction for 60 seconds, the system will exit automatically.
²
The blue backlight of all buttons will go out once the system exits successfully.
4.2
Front Panel Button Control
l
Via Control Panel
²
There are two modes for controlling display and system: synchronous and
asynchronous control mode. They can be selected via the web-based GUI. For
more details, please refer to the
4.6.2 Setting Menu.
u
Synchronous control:
Press the buttons
“ON”
or “
OFF
” on Control Panel to turn on/off the display
