Getting Started
Charging Your Headset
To use your MyVoice 307 Bluetooth headset (“headset”), please follow the steps below:
1. Ensure your headset is fully charged.
2. Pair your charged headset with a Bluetooth-enabled mobile phone.
The headset comes with a built-in rechargeable
battery. Prior to using the headset for the first
time, it is recommended to fully charge the
battery.
Insert the charger’s plug into the headset’s USB
charging socket and plug the mains charger to
an AC wall outlet or plug to the PC/notebook.
5
Use only the supplied charger / USB charging cable to charge the headset.
Charge Plug
Charging Socket
Indicator Light
Headset Status
Status Indicator
• Charging
• Fully charged
• Low battery
• Out of battery
• Out of Range
• Long blue
• The light turns off
• Double flash blue
• The light turns off
• Flash 4 blue every 15 sec until headset
reconnect and timeout after 10 mins
6
Status Indicator
♦
Charging indication will be delayed for a few seconds if the headset has not been used for a long
time or the battery is drained.
♦
3 hours are required to fully charge the headset.
Indicator Light (cont’d)
7
8
Talk and Standby Time
A fully charged battery can offer up to 5 hours of talk time and up to 140 hours of standby time. The
headset remains in standby mode after being turned on.
Pairing Your Headset with a Bluetooth Mobile Phone
1) Ensure the headset is off.
2) To activate the pairing mode, press and hold the headset’s MFB without releasing your finger until its
status indicator showed long blue.
3) Activate your mobile phone’s Bluetooth, search Bluetooth devices, select “MyVoice 307 ” and enter
the passcode “0000”. When the pairing is completed, the headset’s status indicator will flash blue
light rapidly five times.
If the pairing cannot be completed within two minutes after the pairing mode has been activated, the
headset’s status indicator will stay blue five seconds and then turns to standby mode. Repeat steps 1 to
3 to pair the devices again.
Function
Button
Audio
Status indictor
POWER ON
Press and hold
the
MFB
When you turn on your headset for the first time, the headset proceeds into pairing
mode, i.e. the status indicator blinks green, so that you can immediately pair it with
your mobile phone.
a Short beep
Flash blue light 3 times
POWER OFF
Press and hold the
MFB
for 2 seconds
a Long beep
Blue light for two
seconds and then the
light goes off
End a call
Press the
MFB
once
Answer a call
Press the
MFB
once
Incoming call
Ringtone on earphone
Quick flashing blue light
Flashing blue light
Flashing blue light
Using your headset
