Tech One Yak54 EPP Instruction Manual Download Page 4

Page: 4 / 8

11.Glue the control horn by using the CA .

12.Increase the servo arm hole by using the aiguille ,
convenient for installing the pushrod connector.

13.Install the pushrod connector.

14.Install the Z-Bend , tighten the screws by using the
screwdriver.

15.Use the pinchers to cut off the superfluous steel wire.

16.At the junction of the receiver and wing location ,cut a
hole , convenient for the aileron servo wire pass through
easily .

17.Connect the left and right wing with 3 x 100 mm carbon
rod , insert it into the wing slot.

18.Thread the servo wire through the hole till the receiver
location.

－

Summary of Contents for Yak54 EPP

Page 3: ...s the picture shown insert the servo wire into the pre cut slot 7 Use the same method to install the elevator servo as installing the rudder servo 8 Install the left aileron servo 9 Use the same method to install the right aileron servo 10 Pls use a hobby knife to cut a slot which is vertical to the servo arm so that can install the servo control horn easily 2 ...

Page 5: ...es of the joint of the wing and fuselage by using CA C D C D 90 21 Insert the horizontal stabilizer into the fuselage slot using CA glue 22 Use a knife to cut a slot as the picture shown 23 Glue the control horn using CA 24 Glue the vertical stabilizer onto the fuselage 4 ...

Page 7: ... Install the ESC on the right of the fuselage hole and then tighten them with the band 38 Use the knife to cut off the superfluous band 39 Install the lipo battery pack and then fix them with velcro 40 There is a receiver location under the wing connect the servo and ESC wire to the receiver And then insert the receiver into the slot 41 Fix the propeller with O ring 6 ...

Page 8: ...ur careful assembly While assembly the flying weight is really critical to the flight performance and will be affected by adding weight so you should reduce any unnecessary weight while assembly Then you ll get the best flying performance 7 ...