5
LENS LOCK
4G
SOCKET WIRE SLEEVE
LAMP CARTRIDGE ASSEMBLY
CUT OUT
SECTION OF
LAMP HOUSING
Feed the socket wire sleeve back into the lamp housing.
Align the arrow indicator on the lamp cartridge assembly
with the cut out section of the lamp housing. Push to snap
the lamp cartridge assembly into the lamp housing.
8
9
8
9
Install Drywall and Plaster Ring
LENS LOCK
LENS LOCK
5A
3-7/8"
3-7/8"
For housings with round trim holder, mark a 3-7/8"
diameter circle on drywall. Cut out the marked section.
For housings with square trim holder, mark a 3-7/8" square
on drywall. Cut out the marked section.
1a
1b
ROUND TRIM HOLDER
SQUARE TRIM HOLDER
1a
1b
4F
LAMP HOLDER
SPRING
EDGE OF
THE LAMP
Slide the lamp holder spring completely onto back of the
MR16 lamp so that the edge of the lamp snaps into the
lamp cartridge assembly.
7
7
7
5B
Align the cut out section of drywall with the trim holder
and install drywall.
2
2
DRYWALL
TRIM HOLDER
JOIST
WARNING:
The housing is not
intended to be in contact with or covered with
combustible materials and insulation. Do not
install insulation within 3 inches of the housing
sides or above in such a manner to entrap heat.
Risk of Fire:
TIP:
Before installing ceiling, power up and run
the Element fixture(s) for 10 minutes to make
sure all electrical connections are tight.
