9
Use the gray and purple dimming wires for 0-10v dimming application (if not in use, make sure to cap these wires off).
Reinstall the access panel (reversal of section 2A).
10
2C
3
11
Use the gray and purple dimming wires for 0-10v dimming application (if not in use, make sure to cap these wires off).
Reinstall the access panel (reversal of section 2A).
12
2D
Note for In-Line Fuse equipped fixtures:
in the case that the fixture is not operating correctly, make sure to check the fuse.
12
Use the gray and purple dimming wires for 0-10v dimming application (if not in use, make sure to cap these wires off).
Reinstall the access panel (reversal of section 2A).
13
2E
Note for In-Line Fuse equipped fixtures:
in the case that the fixture is not operating correctly, make sure to check the fuse.
Note for Photocell equipped fixtures:
at initial power up, the photocell must calibrate which will cause the fixture to cycle
on/off for a moment.
Note for Photocell equipped fixtures:
at initial power up, the photocell must calibrate which will cause the fixture to cycle
on/off for a moment.
