IMPORTANT SAFETY INSTRUCTIONS.
READ AND SAVE THESE INSTRUCTIONS.
HEED ALL WARNINGS.
This unit is powered by potentially hazardous voltage. Therefore,
observe the following safety precautions:
1.
Read and follow all instructions before using product.
2.
Do not use product near water (such as near a bathtub, washbowl, kitchen sink,
swimming pool, in a wet basement, etc.).
3.
Unit should be located so that its location or position does not impede the flow of
air through the ventilation openings.
4.
Product should be located away from heat
sources such as radiators, heat registers, or other
products, including amplifiers, that produce heat.
5.
Product should be connected to a power
supply only of the type described in the oper-
ating instructions or as marked on the product.
6.
Protect power cord from being walked on
or pinched particularly at plugs, convenience
receptacles, and the point where they exit
from the unit.
7.
Do not allow objects or liquids to penetrate
the enclosure through openings.
8.
During heavy use, chassis may get hot to
the touch. Handle with care.
9.
Protect unit from strong impact.
10.
Unplug product before cleaning. Never spray liquid cleaners into the amp: wipe
with a clean, lint-free cloth to remove dirt and film.
11.
Only use attachments/accessories specified by the manufacturer.
12.
This product should be used only with a cart or stand recom-
mended by the manufacturer. When a cart is used, use caution when
moving the cart/product combination to avoid injury from tipping over.
13.
Amplifiers may be capable of producing high volume levels that
could cause permanent hearing loss or damage, if the exposure to
such levels is prolonged. Such damage is progressive and irreversible! If you experi-
ence any hearing loss or ringing in the ears, consult an audiologist.
2
1
RISK OF ELECTRICAL SHOCK
DO NOT OPEN
CAUTION
CAUTION: TO REDUCE THE RISK OF ELECTRICAL SHOCK, DO
NOT REMOVE COVER. NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
RISQUE D'ELECTROCUTION
NE PAS OUVRIR
ATTENTION
ATTENTION: POUR REDUIRE LES RISQUES D'ELECTROCUTION
NE PAS ENLEVER LE COUVERCLE. AUCUNE PIECE INTERNE
N'EST REPARABLE PAR L'UTILISATEUR. POUR TOUTE
REPARATION, S'ADRESSER A UN TECHNICIEN QUALIFIE.
ELEKTRISCHE SCHLAGGEFAHR
NICHT OFFNEN
VORSICHT
VORSICHT: ZUR MINIMIERUNG ELEKTRISCHER SCHLAGGE-
FAHR NICHT DEN DECKEL ABNEHMEN. INTERNE TEILE KONNEN
NICHT VOM BENUTZER GEWARTET WERDEN. DIE WARTUNG
IST QUALIFIZIERTEM WARTUNGSPERSONAL ZU UBERLASSEN.
This symbol, wherever it appears, alerts the user to the presence of uninsulated dangerous
voltage within the product’s enclosure that may be of sufficient magnitude to constitute a
risk of electric shock to persons.
This symbol, wherever it appears, alerts the user to important operating and maintenance
instructions in the accompanying literature. Read the manual.
14.
Unplug unit during lightning storms or when unused for long periods of
time.
15.
This unit must be earth grounded. To reduce the risk of electric shock, NEVER
remove or otherwise attempt to defeat the ground pin of the power cord. If the provid-
ed plug does not fit into your outlet, consult an electrician for replacement of the
obsolete outlet.
WARNING:
To avoid the risk of fire, electric shock or injury, do not expose this unit
to rain or moisture. Do not remove the chassis from its cabinet, or remove metal cov-
ering from chassis parts. Removing the chassis from its cabinet exposes extremely
dangerous high voltages. There are no user-serviceable parts inside. Hazardous volt-
ages are present inside the chassis. Refer all servicing to qualified personnel.
CAUTION:
Never modify the power cord. If original power cord becomes damaged,
frayed, or has exposed wires, replace immediately with same rating and gauge, or
higher. Replacements are commercially available or you can contact Tech 21 directly.
WARNING:
Attempting to repair this unit is not recommended and may void its
warranty. NOTE: In the U.S. and Canada, servicing is performed at factory only. In
other countries, please refer repairs to the local Tech 21 authorized distributor.
FUSE
Fuse holder is located inside A/C cord receptacle.
You must unplug
and remove power cord to change fuse.
Replace with similar type
and same value: 100V units: use F 1A L
117V units: use F 1A L
230V units: use F 0.5A L
240V units: use F 0.5A L
QUICK START AND STOP INSTRUCTIONS
QUICK START:
Here’s how you can get your Trademark 30 up and running before
you read the entire manual. Note: By not reading the manual, you’ll miss out on how
to get the most out of your new investment!
1. Plug your instrument into the top-panel Input jack (on the left side).
2. Attach the AC cord to the amp and plug into a wall socket.
3. Be sure the Level controls on the Trademark 30 are down, then turn on the amp.
4. Use the quick start sample settings provided on the amp. If missing, please refer
to the Sample Settings in this manual.
5. Play your guitar and you should hear a sound coming through the amp. If not, check
that your guitar’s volume control is turned up, recheck your connections, and be sure your
cable isn’t faulty. If there is still no sound, refer to factory or qualified technician.
QUICK STOP:
After shutting off the Trademark 30 (or any amp),
wait at least 10 seconds
before turning it back on.
