NOTEWORTHY NOTES & CONSIDERATIONS
1) Powering Up and Powering Down.
To avoid the typical loud pop and
potential harm to the speaker and/or horn, power up in this order:
For mono applications:
1st:
Amplifier or pre-amp/processor
2nd:
Power Engine Deuce Deluxe
For stereo applications:
1st:
Stereo processor
2nd:
Amplifier or pre-amp/processor
3rd:
Power Engine Deuce Deluxe
2) EQ.
We recommend starting with all controls flat. Then use each sparingly as
needed for whatever room you’re in. Remember, you need not set everything at max
to obtain maximum results. It would be rare that turning all the tone controls up
would accomplish a favorable sound. In most instances, a slight cut of the Mid
control should be adequate.
3) HPF/LPF Tips.
The LPF and HPF provide expanded flexibility so the Power
Engine can be used with a variety of instruments with different attributes. For exam-
ple, if you are amplifying an electric guitar, engage both filters to simulate the
response of a guitar cabinet. For bass, engaging the LPF only will simulate the sound
of a vintage cabinet. Acoustic guitars will benefit from more high-end response, so
disengage the LPF and engage the HPF to remove boominess. For full range instru-
ments such as keyboards, disengage both filters.
4) Clipping.
Be aware the Power Engine Deuce Deluxe is not designed for use
with a guitar or bass plugged directly into it, as it may cause the tweeter to clip,
especially at higher volume. For optimal operation and maximum headroom, an amp
emulating preamp provides compression to smooth out signal spikes.
11
POWER ENGINE DEUCE DELUXE SPECIFICATIONS
Note:
With on-going product development and improvements, specifications and/or
the cosmetic appearance of this unit may change without prior notice.
Replacement parts
are available, i.e., knobs, logo plate, handles, etc. For more
information, please contact your authorized dealer or Tech 21.
Model Number:
PE-200
1/4” Input Impedance:
1MOhm
XLR Input Impedance:
10kOhm
Nominal Input Level:
150mV / 500mV with Pad
Minimum Load Impedance:
4 Ohms total
Maximum Power Output:
200 Watts RMS @ 4 Ohms (total minimum load)
Aux In Impedance:
10kOhm
Phones Input Impedance:
32 Ohms
XLR Output Level (selectable):
0dB through output (buffered from input)
to -20dB
Maximum Power Consumption:
approx. 280VA
AC Input Power:
100-240 VAC
Cycles:
50/60 Hz
Speaker:
200W - 8 Ohms
12-inch stamped-frame speaker
Tweeter:
3-inch electro-dynamic tweeter
Dimensions:
17.75”l x 17.75”h x 14”w
Weight:
29 lbs.
Optional Accessories:
Black vinyl cover with silver embroidered logo
Model #VC112-LM
12
