2
TECHNICAL FEATURES
Low Profile Finned High Density Aluminum Heatsink
4-Layer Double Sided Circuit Board Construction
PWM MOSFET Power Supply for high power output and best stability into low
impedance loads
Variable High Pass and Low Pass Electronic Crossover
Soft Delay Remote Turn On/Off System for eliminating pop noises
Adjustable Bass EQ at 45Hz (18dB)
Self Diagnostic Multi Protection Circuit with LED Indicator for; Impedance Over-
load, Speaker Short Circuit, Thermal Overheating, and DC Output.
2-ohm Stereo (4-ohm Mono Bridgeable)
Custom Tooled Speaker and Power Terminal Blocks
Variable Gain Control
Low Level Line Inputs and Outputs
INSTALLATION EXPERIENCE
Installation of Gladiator mobile amplifiers requires detailed knowledge of electronics
wiring and proper speaker impedance. We strongly recommend installation by an
authorized Gladiator dealer. This Owners Manual only provides general installation and
operation instructions. If you have any reservations about your installation skills, please
contact your local Gladiator dealer for assistance.
PREPARING FOR INSTALLATION
NOTE: The tools listed below may be required for basic installation
An electric drill with bits
Philips head and standard screwdrivers
Wire strippers
Crimping tool
VOM (electronic volt ohm meter)
Heat shrink tubing and gun
Soldering iron
Summary of Contents for GLADIATOR
Page 1: ......
