FanControl‑GSM v2
6
•
Serial connection requires CAN1 to be connected from vehicle’s side, and CAN2 or CAN3
(dependes on the model of the vehicle) from the climate control’s side
•
Connection manuals are avaliable at www.tecel.ru/en/ and www.canbus‑alarm.
com.
Installation and setting up optional temperature sensors
System receives and uses engine temperature, outside and interior temperature. This data is
used to launch a heater by temperature, for correct operation as a preheater and to inform users
via mobile app and voice menu.
System receives data:
1.
Via CAN‑bus —
only with turned on ignition.
2.
From the heater,
connected via digital bus, only when heater is running.
3.
From the optional sensor ‑ independent of ignition and heater.
We recommend to check:
1.
If the temperature is avaliable via CAN‑bus in a specific vehicle (check www.tecel.ru/en/).
2.
If the the owner is planning to use preheater mode. For this mode outside temperature data
is required, system can receive in via CAN‑bus or via optional sensor.
3.
If the owner is planning to use automatic heater deactivation by temperature and/or
activation of climatic system by temperature. This mode requires engine temperature while
ignition is turned off. System receives this data via digital bus connected heater or via
optional sensor.
4.
If the owner wishes to receive any temperature independently from the engine and heater
state.
You have to install optional sensors minding owner’s wishes and data avaliable in the vehicle
Setup
With micro‑USB‑connector (see figure 3) system can be connected to a PC. You may update
system firmware, set vehicle model, activate preheater mode, set operational time, etc with
TECProg software (check www.tecel.ru/en/).
Also system can be programmed with programming button (PB). PB — one of the vehicle buttons or
built‑in button (figure 3). Which button is used in a specific vehicle — see www.tecel.ru\en\.
Red LED (GSM)
Green LED
(Programming mode)
Micro-USB
PB
Blue LED (GPRS)
Figure 3. FanControl-GSM
