tec lime TTHD-7, Manual

Page: 21 / 26

21
Program selector
1. Press the On
】
key ,when the LED display screen brighten up, rotate the program knob to
select the desired program.
2. Select
【
Delay
】
,
【
Anti-Crease
】
,
【
Intensity
】
or
【
Signal
】
functions for additional option.
3. Press the
【 】
key.
Program start
The drum will keep rotating after the program start, the state light in the display area will flash in
sequence, the remaining time displayed will change automatically.
Note:
Occasionally, the drum might suspend about 40 seconds during the drying procedure, but the
screen displays normal. The dryer is automatically adjusting in this time and will continue
operation.
Program end
1. The drum will stop running after the program ends, the display will show , the state light
of "End" and related light will illuminate. The dryer will start Anti-crease function if user does
not remove the load in time. Please press
OFF key to cut off power and pull the plug out.
2. Deal with the problem according to “Troubleshooting", if there is a unexpected stop during the
drying procedure and the dryer show information.
Special drying functions
1. Intensity
For precise setting of the residual moisture content of the laundry, the degrees of dryness, and can
be set in addition to most programs. Laundry becomes dryer from .
2. The intensity function can be selected only before the dryer program starts.
3. Press the intensity button repeatedly until the light for the residual moisture required is lit.
4. Intensity cannot be set with the programs:
【
refresh
】
,
【
Easy Iron
】
and
【
Time
】
.
2. Delay drying procedure
This function is used to delay the start of drying within 24 hours. By pressing this key continuously,
you can delay the start from1 to 24 hours. The delay time means drying procedure will start in xxH
hours.
The LED display will show delay time after the delay function start. 30 sec later, the dryer will begin
to time, the display will show . Touch the Delay again, the display will show the time of the
program which user choose before. Several seconds later, the display will show remaining time of
delay.
Steps in details
1. Load your laundry and make sure the machine door is closed.
2. Turn the program selector knob and select a desired program
3. You can select the
【
Anti-Crease
】 【
Intensity
】
or
【
Signal
】
functions according to your
need;
4. Press the
【
Delay
】
key;
5. Continue to press the
【
Delay
】
to select the delay time;
6. After the button is pushed, the dryer is under the state of running. The drying procedure
will automatically be performed when the delay time is over.
7. If you push the button again, the delay function will be paused.
8. If you want to cancel the
【
Delay
】
function, please press the key
【
Off
】
and reselect the
program .