Team SILK AX14-60, Instruction Manual

Page: 33 / 92

AX14-60 Flange Facing Machine
32
If mounting the drive assembly onto a flat surface that could obstruct the motor
exhaust slots the exhaust slot blanking plugs must be removed. Place the plugs in
a secure location for re-fitting on completion of the job. Fig 15.
5.2.6 Fitting the surfacing arm
Fig. 17 Positioning the surfacing arm
1. Place the gearbox traverse selector shaft into the neutral position.
2. Slacken off the 3 off 19mm A/F nuts and the 2 off 6mm A/F socket head cap
screws located on the slide way clamp. CAUTION, do not remove the cap
screws completely (see Fig. 18).
3. Slacken off the 4 off 10mm A/F socket head cap screws under the slide way
heel clamps (see Fig. 18).
4. Using suitable lifting apparatus lift the surfacing arm onto the drive hub
assembly ensuring the surfacing arm is clean and free from debris. Position the
arm under the slideway clamp and 4 off separate slideway heel clamps.
5. In some circumstances it may be easier to remove the heel clamps prior to
fitting the surfacing arm. Refit them after the surfacing arm is located on the
drive hub.
Surfacing arm
Toolpost
Heel clamp