Chapter 2. Setup
2-2
Quick Installation Guide
You’ll Need These Tools
•
7/16-inch socket
•
3/4-inch end wrench
•
#2 Phillips screwdriver
•
11/32 socket or hand driver
•
T15 tamper-proof Torx
driver
•
T27 tamper-proof Torx
driver
•
3/8-inch socket or hand driver
∆ WARNING
Restraining cables.
You might need to angle the
front glass beyond the extent of restraining cables.
(The same applies to the LCD.) In that case, you must
disconnect these cables. Take care to protect the
fragile glass and LCD. Don’t let them free-fall out of
the cabinet! The LCD might slam into the control panel
and break. The front glass could snap or splinter.
Before resting the glass and LCD on the CPU (Pod)
cabinet, remove the top panels. Otherwise, the glass
or LCD might shatter against the player button. Shards
of glass could fly in every direction.
CAUTION
Shipping Screws.
You
must
remove the shipping screws. Leaving them in might damage the LCD.
See Step 9.
[ ] 1.
Remove the game machine from its shipping
skids.
There are three pieces on two skids.
[ ] 2.
Check for shipping damage.
[ ] 3.
Stand the LCD
(large)
cabinet upright.
[ ] 4.
Adjust the LCD cabinet leg levelers.
[ ] 5.
Remove the two screws that secure the
upper front speaker panel. These screws are
on the sides of the LCD cabinet.
[ ] 6.
At the top of the LCD cabinet, remove the
foam shipping insert. This insert is under the
cable support that attaches to the ball
trolley.
[ ] 7.
Remove the hex bolts that secure the front
glass to the cabinet frame.
[ ] 8.
Pivot the viewing glass forward.
[ ] 9.
Remove the two shipping screws from the
LCD panel.
Removal reduces the chance of
LCD damage.
[ ] 10.
Unscrew and remove the metal access panel
at the bottom-front of the LCD cabinet.
[ ] 11.
Remove the two top panels from the CPU
cabinet (Pod).
[ ] 12.
For this step, use four bolts with flat and
lock washers: Assemble the LCD cabinet to
the CPU cabinet (Pod).
[ ] 13.
Connect the cables between the LCD cabinet
and CPU cabinet (Pod):
Ten connectors.
[ ] 14.
Adjust the CPU (Pod) cabinet leg levelers.
[ ] 15.
Load the balls
(minimum: four).
[ ] 16.
Assemble and install the marquee. (See
Assemble and Install the Marquee
, p. 2-6.)
[ ] 17.
Bolt the marquee to the LCD cabinet roof.
On each side of the marquee, use two half-
inch, number 6 sheet metal screws.
[ ] 18.
Turn on the power switch.
[ ] 19.
Verify that the game starts and Attract Mode
runs.
[ ] 20.
Set pricing as you want it. (Use these menu
settings: Coin 1, Coin 2, and Price Per Play.)
[ ] 21.
If you’re satisfied that the game machine
operates properly, reinstall the bottom LCD
access panel.
[ ] 22.
Reinstall the two top panels on the CPU
cabinet (Pod).
[ ] 23.
On the LCD cabinet, pivot the speaker panel
back against the viewing glass.
[ ] 24.
To secure the speaker panel, reinstall the
screws that you removed earlier.
Page 2 of 12
Copyright 2015 Team Play, Inc.
